Today, a leaked OS for the BlackBerry Z10 version 10.1.0.1429 has leaked which claims to contain the full 10.1 OS.
This OS currently supports STL100-2, STL100-3 and STL100-4 devices only.
Download Links:
Instructions for those who require it.
Download the file that you need from the links up above. Make sure you download the correct version for your device.
Use winrar to extract the autoloader from the rar file. If you do not have winrar installed, you can download a free trial here.
Note that this process will erase everything on your BlackBerry Z10, so back it up first if you wish to restore anything.
Turn off your BlackBerry Z10.
Run the file that you just extracted.
Connect your Z10 to your usb cable and quickly turn it on.
The autloader should connect to your Z10 and start the process.
Sit back, have a coffee or a tea and wait until the process is finished.
When the autoloader has written 100%, the program will terminate and the window will close.
Disconnect your BlackBerry Z10 and wait for it to reboot.
Your BlackBerry Z10 will now be in the position that it was in when you purchased it, so set it up as you normally would.
BlackBerry Z10 version 10.1.0.1429
Any changes that I notice was published here.
source by (rapidberry.net)
DISCLAIMER: Install at your own risk. This is Leaked software that is not guaranteed to be stable, and therefore will not be supported by BlackBerry or your wireless carrier should you run into any problems. As a precaution, if you decide to upgrade, it is highly recommended that you make a backup before using this software. If you are not comfortable using Leaked software, I highly recommend you wait for the next official release.
thanx for watching this, Comment below for further details. And Don't Forget to Like my Facebook page Techno world.
0 comments :
Post a Comment
Thanx for all your Feedback .... and don't post to promote your site's ...
I kept the option as Comment moderation mode. So if you try to promote your site from here.. I do delete your comment's ..